Unable to load Training Config File
Posted: Tue Sep 03, 2024 9:55 pm
Hello, I've been trying to do some classification tests with 3DMASC in cloud compare to see if it does a better job of identifying Coarse Woody Debris (deadfall), Vegetation, and bare earth in a forestry scene than Canupo. Unfortunately, even after after following the youtube tutorial (https://www.youtube.com/watch?v=6z40FLN ... HV&index=8) and reading the documentation (https://lidar.univ-rennes.fr/node/11) I still seem to be struggling with the config file.
I am able to open the Train Classifier dialogue to choose the PC1 cloud, but after clicking OK I receive a popup, and a message in the CC console, which states "Failed to load the training file"
Here are the parameters I am working with, any help figuring out this issue would be most appreciated!
# NAMES
cloud: PC1= #Point Cloud for training, leave as = so you can choose a cloud loaded in Cloud Compare
# CORE POINTS
core_points: PC1
# SCALES
scales: 0.1;0.5;1;1.5 #scales as a list
# FEATURES
feature: INT_SC0_PC1
feature: Z_SC0.5_PC1
feature: ZMAX_SCx_PC1
feature: ZMIN_SCx_PC1
feature: ZRANGE_SCx_PC1
feature: SPHER_SCx_PC1
feature: LINEA_SCx_PC1
feature: PLANA_SCx_PC1
feature: ROUGH_SCx_PC1
feature: CURV_SCx_PC1
feature: ANISO_SCx_PC1
I am able to open the Train Classifier dialogue to choose the PC1 cloud, but after clicking OK I receive a popup, and a message in the CC console, which states "Failed to load the training file"
Here are the parameters I am working with, any help figuring out this issue would be most appreciated!
# NAMES
cloud: PC1= #Point Cloud for training, leave as = so you can choose a cloud loaded in Cloud Compare
# CORE POINTS
core_points: PC1
# SCALES
scales: 0.1;0.5;1;1.5 #scales as a list
# FEATURES
feature: INT_SC0_PC1
feature: Z_SC0.5_PC1
feature: ZMAX_SCx_PC1
feature: ZMIN_SCx_PC1
feature: ZRANGE_SCx_PC1
feature: SPHER_SCx_PC1
feature: LINEA_SCx_PC1
feature: PLANA_SCx_PC1
feature: ROUGH_SCx_PC1
feature: CURV_SCx_PC1
feature: ANISO_SCx_PC1